This site uses cookies.
Some of these cookies are essential to the operation of the site,
while others help to improve your experience by providing insights into how the site is being used.
For more information, please see the ProZ.com privacy policy.
This person has a SecurePRO™ card. Because this person is not a ProZ.com Plus subscriber, to view his or her SecurePRO™ card you must be a ProZ.com Business member or Plus subscriber.
Affiliations
This person is not affiliated with any business or Blue Board record at ProZ.com.
Translation - English Microcomputer Water Temperature Water Lever Controller
Installation and Use Instruction
Power off memory
Water temperature preset
Intelligent heating
Water insufficient alert
Leakage protection
Constant heating
Pipe warm keeping
Water lever preset
intelligent water loading
Auto water loading
Low pressure water loading
Constant water level loading
Manual control
All-weather water supply
Auto control boosting pump
Installation Drawing
1.connect to water supply
2.hot
3.cold
4.ball valve
5.controller
6.electric magnetic valve double core connection cable
7.electric magnetic valve
8.
TK-7 Controller Guara Tee Card
User Name
Use Address
Product Model
Export Date
Reference No.
Telephone
Purchase Date
Signature of factory
Installation
the junction box under the controller
the water temperature sensor plug to the pin which is green be tight and put them to the channel be fastness, bracket on the place no water drenching and easy to be red,fastness by screw.the controller on the bracket , connect the line of the solenoid , boost pump, heater belt and heat tube to the junction based hookup, no wrong connection, otherwise, will damage the ment, please choose the keep temperature or pump. Connection line can come out from three position on the right left, then cover the box, after checking no wrong, put on the for self checking.
Water level and temperature sensors assembly, the cable grant into the over fall pipe and then put the sensor the over fall pipe and draw the cable slightly to get connect to entrance and then push the cable to the over fall pipe about 1 then fix the cable by pressure plate.
The cable to the room, and tight the cable out side to prevent broken, the sensor do not too close near the electric heater or touched, drench the plug or to be wet when assembling, is the bottom sensor, the sensor install under the bottom of t(see the installation drawing)
volenoid valve install
direction: the water in and out is different, the side with is the water in, the arrowhead show the water direction , cable connect with the solenoid valve, and the cable could be , the thick cable is better.solenoid valve of the TK-7 has the check valve, it is no need the check valve again.
Choose the soft or easy take off pipe to connect the side come in for the cleaning the filter.
Or using our product, the TK-7 solar water heater micro controller is design for solar water which has the new SCM and colorful display for water level and temperature, auto, design for human personality, temperature and water, low water level alert, water leaking prevent, leakage manual control, all -weather water supply, low water pressure instant temperature heating and constant water level loading, auto control and pipeline heating could be chosen for hot water consumption user, it is featured by easy and practicality.
OV AC Power loss:
More
Less
Experience
Years of experience: 23. Registered at ProZ.com: Jun 2008.